Categories
Services
Information
Pre-Calibrated field Replaceable Sensor ModuleALcoMate Prestige is the first breathalyzer that offers pre-calibrated and field replaceable modules (patent-pending) in the market. One of the main problems with using breathalyzers in critical applications is that the alcohol sensor requires periodic re-calibration. Unfortunately, the re-calibration process requires that the breathalyzer be physically mailed or taken to a professional service center. The process is costly for both consumer and service center, and the delay of processing and shipping back-and-forth can be quite a loss. |
$29.95
|
|||||||
The Pre-Calibrated Replaceable Alcohol Sensor Module eliminate delays and complications of re-calibration by allowing you to simply "snap out" an old module and "snap in" a new one. This way, you can get back to reliable and accurate testing in a matter of few minutes! |
||||||||
 |
 |
 |
||||||
| Prepare your AlcoMate Prestige. | Use a flat, sharp tool to carefully open the top cover. | Lift the breath tube to access the sensor module. | ||||||
 |
 |
 |
||||||
Remove the breath tube. It should remove easily |
Carefully raise the sensor module from the body. Do NOT detach the cable from the body. |
Remove the cable from the slot underneath the sensor module. |
||||||
 |
 |
 |
||||||
Prepare a new pre- calibrated sensor module |
Insert the cable into the new sensor. Make sure the blue strip is toward the sensor, as shown. |
Replace the sensor module into its original position. |
||||||
 |
 |
Ready For Use |
||||||
Re-attach the breath tube directly on to the sensor. Make sure the front opening is aligned. |
Re-attach the cover on to the top of the body. It should snap in fairly easily. |
|||||||
